Just How Do You Install Dirt Bike Graphics

Substance Incorporated is our long-term partner in dirt bike graphics. Substance Incorporated, a market leader in the production of motocross graphics that can be used for screen printing as well as digital printing is a company with unparalleled enthusiasm and innovation. Check out https://www.facebook.com/decallaboratory/ website for effective information about dirtbike graphics now.

Just before you start
It is worth checking the state of the plastics you have. If they're damaged or damaged, it could be worth replacing them. Before you can attach dirt bike graphics kits, the dirt bike's plastics must be in good condition.

You'll need the following to install dirt bike graphics:
Adhesive paper tape
paper knife / scissors;
Hair dryer or heat gun
Alcohol-water, also known as a degreasing agent or alcohol.
squeegee (optional);

Cleanse your hands. It is crucial to clean your hands before you are preparing surfaces or working with graphics. Hands that are dirty or oily will hinder the ability of the dirt bike's graphics to adhere.

Preparing area
Before you can begin to install dirt bike graphics, it's necessary to remove old decals. Hair dryers or a heating gun can be used to warm up old graphics until they are easy to remove. Degreasing agents are able to clean the surface. It is crucial not to leave any glue residues left by old graphics, oil or dirt. When applying motocross graphics to dirt bikes, the plastics should first be warmed up. We recommend that you store the your plastics in a room that has a temperatures of more than 15 degrees Celsius or 60oF for a few hours.

Graphics
Put your dirt bike's name over the surface of plastic. Number plate Using the aid of adhesive tape place the decal using adhesive paper tape on the surface of the plastic. This will secure your decal in the correct position. You can apply as much tape as you like. Remove the backing paper from the background. Make sure you are aligned with the area that you wish to protect. To position the graphic in the desired location, touch one side using your fingers.

You can create sections by using your thumb or squeezer to apply pressure on the graphic. Make sure to avoid creating bubbles and wrinkles. Begin with the center. Remove any bubbles by gently peeling the section off, then retry. To pop air bubbles that are small, use the safety pin. Smooth the bubbles to the edges of the graphic. It is possible to repeat the process on the opposite part of the decal.

If you have sharp lines in your plastic Use a heating gun that is electric to melt the graphics to make them more flexible. Be careful not to overheat!

If needed cut off excessive portions or graphic that cover bolts, vent holes, or access slits. We recommend using a the paper knife.

Installation techniques
Be patient and patient! It's not as hard as you may believe.
For several hours before installation make sure that you keep your plastics and dirt bikes in place at temperatures of greater than 15degC/60oF over a period of time.
To ensure that bonding is secure to ensure that bonding is properly secured before riding.